Specifications
HydroTap Classic Tap (CS)
Hole Size
1 - 3/8” / 35mm
Tap Height
8 1/4” (209mm) or 13 13/16” (351mm) when installed with the optional font extension
Installation
Over sink as a secondary tap or on optional font/drip tray
Flow Rate
Max 1.8 gpm / 6.81 lpm
Sparkling Water Flow Rate
0.4 gpm / 1.51 lpm
Product Certifications
IAPMO - NSF/ANSI 372, 42, 53, CSA B438.1, ASSE 1023, ASSE 1087; cUL; CEC
Water Pressure
Min 37psi – Max 100psi (2.60 - 7.03kg/cm2 ) with a minimum flow rate of 1 gpm (3.79lpm)
Water Connection
½” BSP - isolation valve is required within 3’ (0.9m) of the installation
Integral Water Values
All HydroTap systems are fitted with a Dual Check Valve and a 50psi (3.52kg/cm2) Pressure
Limiting Valve
Water Supply Requirements
Potable drinking water supply
Optimal Total Dissolved Solids (TDS) Range
TDS Min 50ppm – Max 150ppm
Integral Water Filter
0.2 micron, 1 size - replace every 1,100 gallons / 4,163 liters or 12 months
Power Rating
110-120V, 50-60Hz, 15 amp power supply with a NEMA 5-15 outlet
Dimensions (WxDxH)
13.3” x 18.2” x 13.1” / 339mm x 462mm x 333mm
Minimum Air Gap
Minimum of 2” / 50mm clearance on left and right side and 8” / 200mm above
Minimum Cabinet Size
20” wide x 24” deep / 508mm wide x 610mm deep
Maximum Hose Connection Length
3’ / 0.9m (tap to command center)
Minimum Distance Needed for Installation
15” / 381mm (interior wall to garbage disposal)
Product Approvals
IAPMO - NSF/ANSI 372, 42, 53, CSA B483.1, ASSE 1023, ASSE 1087; cUL; CEC
Compatible CO2 Cylinder
Zip Water 1.5lb CO2 or 5lb CO2 (if space allows) with CGA-320 fitting
CO2 Operating Pressure
Min 39psi - Max 44psi / Min 2.74 - Max 3.09kg/cm2
